|
| 貨號 | |
| 品牌 | TR 214 Liquid Mold Release |
| 是否危險化學品 | |
| 型號 | TR 214 Liquid Mold Release |
| 產品等級 | 其他 |
| CAS編號 | |
| 純度 | 98% |
| 別名 | TR 214 Liquid Mold Release |
| 密度 | 1.3g/cm3 |
| 產地/廠商 |
TR 214 Liquid Mold Release
Liquid mold release is recommended for use on fully cured, well conditioned molds only. It is not recommended on new or reconditioned molds until at least eight or ten parts have been pulled using paste wax. It should not be used as a final coat over paste wax as the high solvent content is provided to remove wax and wax build up. Rapid settling of liquid waxes requires shaking well immediately before and during eacch use.
Directions: On clean surface apply a small amount with brush, spray, or cloth. Be sure entire area is covered. Allow to dry and brush or wipe off. Excellent on, nonskid, grained, or sand type finsihes. Repaet as required.
TR 214液體脫模
液體脫模建議僅用于完全固化、條件良好的模具。不建議在新的或翻新的模具上使用膏蠟拉出至少8或10個零件。它不應該用作膏蠟的*后一層，因?yàn)楦呷軇┖渴怯脕砣コ灪拖灧e聚的。液體蠟的快速沉淀需要在每次使用前和使用過程中立即搖勻。
使用方法:在清潔的表面上，用刷子、噴霧或布涂抹少量本品。確保覆蓋整個區域。晾干后刷掉或擦掉。優良的表面，防滑，顆粒，或砂型飾面。按要求補藥。
